the new QuickConfig screen is used to quickly configure the airlogOne on the go. As before, detailed configuration is carried out via the airlog.app dashboard.
In principle, the settings are self-explanatory. They include
Timezone: as UTC +/- x (The time zone is set automatically if GPS reception and Internet access are active) Autostart: trigger altitude to start track recording
Alti Units: Unit of altitude display (all other units only via airlog.app)
Refresh: time until the refresh cycle, which maintains the screen contrast in strong sunlight
FLIP: rotates the image 180 degrees for attachment to the chest strap
second page
Track type: CSV is the native format of the airlogOne that contains all data, FLS is the compatibility format for a Flysight analysis workflow
Wind Info: allows the recording of the altitude-graded wind forecast if the device is set to “WEBMODE” = Internet access before the jump. This selection is only available in CSV mode
Active Target: Selection of one of the 5 saved targets, which are retained even after the device is switched off and are shown in the display with a name abbreviation
Screen Mode: Selection of the start screen after switching on, normally “ALTI/TRACK” but also any of the discipline- specific screens
CP altitude: Height of the virtual 3D target point for the HOME position (set with the SetDZ button)
SAVE config in non volatile storage
Configure
The user interface is based on three buttons: UP (left) OK (center) and Down (right)
UP increases the displayed value
OK confirms the value and jumps to the next configuration step DOWN decreases the value
The action is activated when the button is released. If the OK button is pressed for longer than one second, it jumps back one configuration line.
Each press of the button is signaled by a short tone.
All configuration lines must be scrolled through until the new configuration is saved. After saving, the airlogOne restarts with the new configuration.
The configuration can only be canceled by a reset: press and hold the left and right buttons simultaneously for approx. 3 seconds. The device restarts without having changed any entries.